Dear all,
One more time I got some doubts in stress analysis and hope you can help me again.
Usually, I created some cases for analysis that is:
• an operational case (full case W+P+T);
• an assembly case (no contents and exposed to sun WNC+T);
• and other cases, mainly occasional loads.
I'm in doubt if this “assembly case” is a common practice in stress analysis. I consider as temperature for exposition to sun about 70°C. This may causes a lot of problem due a high displacement of pipeline and as consequence, rotation of nozzles. Do you use some kind of case like this?
Can you help me again?
Regards,
Miyamoto