Good afternoon, I need to know how to resolve the fatal error 130 in the program tank version 3.30.

"During the attempt to determine the required thickness of the annular bottom plate, the nominal plate thickness of the bottom shell course exceed the table maximum of 1.75 inches"


Thank you,

Regards

Elaine Urbina

Take a look at the API table referenced in the message (Table 3-1). Notice that the table only goes as far as a bottom shell course thickness of 1.75 inches. You're exceeding that, hence the error message.

That sounds very strange, this shouldn't happen. If you have reviewed your input and still can't find the problem, open a Support Request on eCustomer and submit your job file for review.

Thanks a lot Richard,

Have a good day

Elaine