I am wanting to perform a nozzle assessment to API 685, i.e. for a canned motor pump. Is there any way i can do this within Caesar, as far as i am aware there are only API checks for 610, 617, 661 and 560.
Unfortunately i only have the allowable loads for API 685. Is there any way of extracting the allowables which Caesar uses for API 610 so that i can compare them?
Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
No you can't extract the data from CAESAR II. The only way to see if the limiting loads are the same would be to compare the two Codes. Even if the load limits are the same, are the same equations used?
_________________________
Regards, Richard Ay - Consultant
I do not have access to the whole code so i am unable to verify which equations are used in API 685. It appears i will have to provide my pump supplier with the loads to be induced on the pump nozzles, i note that there are methods of qualifying nozzle loads in excess of those quoted in the standard.