Hi,

I wnat to run analysis as per DNV. I have updated tensile strength values in material data base & also I have used values for Ns, Nu & N.

But when I look at the results it does not show any allowable stress value.

Can you please tell me how to check anaysis as per DNV in caesar?

Regards,
Kaustubh

Send your model in to Tech Support so we can take a look at it.

hi

In DNV code check is it possible to check the occasion cases like wind sesmic and blast.

if it is possible please explain

hi

In DNV code check is it possible to check the occasion cases like wind sesmic and blast.

if it is possible please explain

You can setup any load cases you want. The Code Stresses are computed based on the computed element loads.

thanx richard

i built the load cases for wind and sesmic but while checking the stresses out put there is no impact on the results same results are showing for all the cases

for sus case also same code stress
for wind and sesmic also same code stress

can u please clarify