Hi all

which diameter of the pipe should I enter In CAESAR II 5.20: the nominal size or the outside diameter? Cause I'm working with ANSI SPEC but I'm using millimeters in my input.

Check "Nominals" in the "units files". If the flag is "ON" then you can enter nominal size. It will be converted into outside diameter

Best regards,

Thanks but where can I find the unit file?

Regards,

Go to "Main menu" then "Tools" then "make units file" then "Review existing units files" and choose your units file.

Regards,

I find the unit file then I chose EDIT but I got a page with all units used for input but not any flag to put 'on' can you tell me how I can find the nominal size flag to put it 'on'?

here.

Thank you Mr Dan

I was editing an existing unit file that's why I got a different table but when I chose 'create a new file' then 'Edit' I got the same table that you post.

Best regards,