Hi,
I am doing WRC 107 for the first time.
My main unit file is having following units
dia=mm
Thickness=mm
Corrosion allowance =mm
Force= Newton
Moment=Nm
Temperature=degree celcius

But while WRC 107 analysis calulated everthing in FPS system and the analysis report is also FPS.
Is there a way to make WRC107 units consistent with my main unit file so that i dont have to convert units.


Regards

You have to wait until will be fixed.

Read this:

http://65.57.255.42/ubbthreads/ubbthreads.php?ubb=showflat&Number=40796#Post40796

Regards,

Thanks for your valuable help

Do we need to include the design presuure of vessel

As we already include pressure in caesar load case like
SUS= W+P
OP= W+P+TI

do we still need to include it in WRC 107 calculation

There are a lot of posts on this subject and there is also a webinar at this link:


http://coade.typepad.com/coadeinsider/2011/02/pv-elite-webinar-local-stress-analysis.html

Regards,

Just to start, see this one:

http://65.57.255.42/ubbthreads/ubbthreads.php?ubb=showflat&Number=140#Post140

Regards,

And this one(see the attachment inside the post) :

http://65.57.255.42/ubbthreads/ubbthreads.php?ubb=showflat&Number=26889#Post26889

Regards,

Thanks for providing this inforamtion.My nozzle fails the moment i activate the thrust pressure in WRC 107 calculation.Well i still cannot find a clear answer weather to include it or not.The vessel has been running on site for past 5 years without any problem and i belive the thrust pressure is within allowable otherwise how could it have been on site working for 5 years.
I think PV elite guys will have a solution for this