Hello,
When I generate the report I am getting the following warning:
"WARNING, the 5.10.3 checks have failed,
probably due to the Structural Member Allowable
Stress being specified too high. This value is
being reduced by 1000 psi and the member design
restarted. "
The material of the roof is NS235 and material of the structural members is A-36.
"---/ For Supported Cone Roof Design /---
Preferred Rafter Type (W, WT, S, C) ................... W
Preferred Girder Type (W, WT, S, C) ...................
Preferred Column Type (W, WT, S, C, DC, DI, P ) ....... P
Roof Plate Material ................................... NS,235
Roof Plate Allowable Design Stress ........(KPa ) 0.13789E+06
Structural Member Material ............................ A-36
Structural Member Allowable Design Stress..(KPa ) 0.15995E+06
Maximum Allowed Rafter Length ....................(m. ) 7.7940
Maximum Allowed Girder Length ....................(m. ) 0.30480
Center Column Cap Plate Diameter .................(m. ) 1.2500
"
Could you please explain why I am getting this error and what should I do to fix this issue?
Thanks