Our engineers don't like the node numbering from the CADWorx export and don't trust the designers to set the start points and so on. Even then the node numbering doesn't completely follow their guidelines. Batches of nodes can be re-numbered from the list but in anything but the simplest of models its hard to get the right selection of nodes that way. Is there a means of selecting a run on screen then renumbering that selection?

Not at the present time, but recently we've received this request several times. I'll see that this is added to the development list.

Thanks. The new 2011 release shown in the webinar had some very nice improvements - you guys are very responsive to users!

Thank you, we try.