Please note that in the WRC 107 analysis in Codec calculation, while importing the model the actual hub thk and diameter is not imported, Please look into this matter.

May I ask a question? Imported from where?

Dear Ray,

He is importing the nozzle data from his "Pvelite model with nozzle connections".

And he is emphasizing the following query:

1) In PVElite, he has modeled the "Hub type nozzle" & while importing that configuration in code calc, actual nozzle diameter (i.e. Nozzle OD including hub thickness) is not imported.

& I also agree with him:

For eg:

Nozzle OD : 610 mm (24" OD)
Nozzle Neck Thk : 20 mm
Hub Thk : 40 mm

After importing in code calc, nozzle actual OD shows as

610 + 2*40 = 690 mm

However, actual OD shall be

(610-2*20) + 2*40 = 650 mm

Hi Mr Shulkla

The moral of the story is to use PV Elite. I am curious as to why you would use CodeCalc?

Yes you are correct,

But some times we have found that while entering the forces & moments in PVElite & saw the result by pressing "quick calculator" button our result was actually passed in that quick calc window.

But after designing whole equipment & ran the PVElite, the same nozzle failed.

That is why we prefer Code calc for it.

For your info, this had happened in 2006 or 2007 version & this happened once or twice but not frequently

Ok

I see your point. Of course, the user can use any method he/she chooses to get the job done.

I will review and get back to you.