Dear All,

I am facing a problem from since 10-15 days.Before this all was right.
After giving all input data in CAESAR-II when I am going to RUN the analysis , sometimes it is not giving the STATIC OUTPUT PROCESSOR window, Incore Solver window is just runing continiusly & after changing some input data it is showing
the STATIC OUTPUT PROCESSOR .


So give me some solution , so that I can fix this problem.


Regards
GRD

When you have a job with non-linear boundary conditions, the solution must "iterate" until convergence is reached. If convergence doesn't occur, the "Incore Solver" keeps trying. There are a number of posts in this forum that discuss "convergence", please search and review these. There is no specific single solution to this issue (other than you have to change something).

Dear Gyana,
this is mainly due to convergance problem as Richard said.