Dear Piping Experts

Could you please shed some light on how to check for crashing load and for stress in thing-wall CS/SS piping to make sure they are not excessive for cases as follows:
- Bare pipe supported from the steel
- Pipe is on a shoe with no re-pad
If you can share a validated spread sheet for performing this calculation or refer to a proper source, your kind help will be truly appreciated.

Thanks and have a great day

Vikoll

Dear Readers
I do apologize for a confusion. My question was about “crushing” load in a “thin” wall piping. I will be reading my posts before submitting and not doing this in rush.
Thanks,
Vikoll

Dear Readers
I do apologize for a confusion. My question was about “crushing” load in a “thin” wall piping. I will be reading my posts before submitting and not doing this in rush.
Thanks,
Vikoll