ALL DEAR

RECENTLY WHEN I WAS DOING SOME SIMULATION OF TOWERS I DECIDED TO COMPARE THE WEIGHT OF SOME NOZZLES, TO MY SURPRISE WHEN THE PVLITE COMPUTED THE WEIGHT OF A NOZZLE OF DIAMETER = 36" , IT WAS LESS THAN THE WEIGHT OF NOZZLE OF DIAMETER = 24". DOES SOMEBODY KNOW HOW THE PVLITE CALCULATE THE WEIGTH FOR LARGE NOZZLES (UP 36")? BECAUSE I THINK THAT THE VALUES GIVED FOR PVLITE ARE BELLOW THE REALITY.

THANKS

Dear PV Elite user,

Send your PV Elite file (*.pvi) file to COADE tech support ( support -at- coade -dot- com ) and indicate the version and build of PV Elite that you are using.

OK, THANK

I WILL SEND YOU, INCLUDING WITH OTHER SIMULATION THAT PRESENTED THE SIMILAR PROBLEM.

Dear botaodaniel1313,

I know that there is one bug in PVElite that he takes a wrong pad width of the reinforcement plate. Maybe you can put the pad width once again in Pvelite.

To following steps i do to make sure it wont go wrong;
1. Put the Pad with in the input section
2. then use 4 or 5 times ; TAB.
3. Recalculate weight.

HELLO Kinge,

THANKS FOR YOUR ANSWER, BUT I THINK THE PROBLEM IS NOT THIS, BECAUSE EVEN WITHOUT REINFORCEMENT PLATE THE WEIGTH OF NOZZLE 24" IS GREATER THAN NOZZLE 36", BUT ACTUALLY THERE IS THE PROBLEM THAT YOU SAID PREVIOUSLY. WHAT I ALREADY NOTICED IS THAT THE PVELITE DON'T CONSIDER THE WEIGTH OF BLIND ATTACHED FOR NOZZLES UP 36".

WOULD YOU ABLE TO DO A TEST IN YOUR PVELITE E LATER GIVE ME A REPLY ABOUT THIS TEST? THANKS I HOPE YOUR ANSWER.