Dear all,

i have a problem here to modeling the base support with u-bolt at 12" elbow where the position of u-bolt is at 329 mm from elbow center radius, so CAESAR will said that the curvature radius is not enough. This is an actual condition in site, and i try to modeling it just like actual condition to analysis the load in all support and vibration case with pipe connect to a submersible pump in a well. And one more question, if i modeling the submersible pump with its own weight where, is it right or wrong? it is my first case with submersible pump in a well. Please see the DWG for reference.
i hope that i can get valuable input, please enlighten me.....Thank you very much.


Best Regards

LNG