Hello Everyone,
I have selected Von Mises in the Config Editor but all my analysis results show that the 3D Max Intensity has been used?
Anyone knows why? Can this be changed now that I have completed the job or can I change this and run the analysis again?

Regards
M Aminu

Hello,
Has anyone experienced this with CII 5.20, this does not happen with 5.10 which I just tested.

M Aminu

Actually I don't think this works in 5.10 either, at least it didn't for me just now running 5.10.03.

I'll get this fixed, thank you for pointing this out.

Sorry to bump an old thread, but has this been corrected yet? I'm using 5.2 and have the same problem...

Robbie99,

Did you run your job throuogh the error checker? This step is necesary to apply new settings to the analysis.

And I do mean passing through the error check, not simply re-analyzing the model after changing the configuration setting.

Yes I ran the error check before running the job, and I have built a new model from scratch with the von mises setting applied but it still uses the max intensity instead of Von Mises.