ASME BPVC Section I - Intergraph CADWorx & Analysis

You are not logged in. [Log In] Home Page » Forums » Analysis Solutions » PV Elite » ASME BPVC Section I

Topic Options

#27727 - 05/26/09 09:37 AM ASME BPVC Section I
Fabiano Member Registered: 01/16/08 Posts: 13 Loc: Brazil	Dear all, Can anybody help me with Section I calculation? In PFT-51.1.2, the code describes the method for evaluation of the maximum allowable external working pressure, which is just like Sec. VIII procedure. However, in the case of a cylinder with definite pattern openings, what consideration should I use to consider these openings? Should I include the ligament efficiency? Best regards. _________________________ Fabiano Rosa Equipment Engineer - Operating Director SANDECH \| Engineering and Management Consulting
Top

#28631 - 07/16/09 02:16 PM Re: ASME BPVC Section I [Re: Fabiano]
Ray_Delaforce Member Registered: 01/02/03 Posts: 743 Loc: Houston, TX	Hi Fabiano I am sorry about the delay in answering you question. Section I is for power boilers, and we do not include it in any of our software. _________________________ Sincerely, Ray Delaforce CADWorx & Analysis Solutions Hexagon PPM
Top