If the Z-axis choose vertikal then the axis Y and
Z only be exchanged.
This is no more riht turned coordinatsystem.
I think the Y axis in coordinate system where Z- axis vertikal must change its direction about 180 dergree ?

Dear Mr. Ohliger,

We had the same problem in the past. But from CII 4.5 build 040528 on, the coordinate system is ok again when using the Z vertical option.

Best Regards und viele Grüße,

... and the problem was only with the graphical representation of the compass.

Please note that on "View Animation - DynPlot" screen the coordinates are always indicated as y-up, even when the job setting is with z-up. Please correct this in the next version of Caesar.
Regards
Ranka