Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
From looking at your screen shot (your running Version 5.00) and the error message, I'd say you have obtained a neutral file generated by Version 5.10 and you're trying to create a 5.00 model ? For this to work, you'll have to edit the neutral file and manually remove any data that was added for the 5.10 release. If the model is relatively small this isn't a big deal. For large models this is quite a task to do properly.
_________________________
Regards, Richard Ay - Consultant
Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
It doesn't matter whether the data is defined on the spreadsheet or not. When you generate the netural file Version 5.10 writes two lines for this data. If you haven't defined anything, then zeroes are written. The point is that there are two extra lines of data (for each element) in a 5.10 neutral file compared to a 5.00 neutral file.
_________________________
Regards, Richard Ay - Consultant
I am having this trouble of converting a neutral file to caesar ii input file. A run-time error occurs which says "forrtl:severe (29): file not found, unit 54" . If you have encounetered and solved this kind of error before, please show me what to do. Your help is very much appreciated.