Hi ! robin!! thx for your solution but as we model valves & flanges as a rigid element & fluid can pass through it.So again how we can model rigid as a blind flange which is used to close the pipe section.May be it is a bit stupid question but plz if you know answer let me know.. thx..
Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
CAESAR II is a pipe stress / flexibiltiy program (not a hydraulic program). There is no "flow". The only reason you would model a "blind flange" is to include its weight (load).
_________________________
Regards, Richard Ay - Consultant