Hi guys,
I would like to know why for some materials CAESAR II doesn't give the hot and cold allowable stress ?

and

where can I find these datas for Hastelloy B3 (UNS-N10675) and Sanicro (UNS-N08028)?

Thanks in advance.

Best regards

Read these earlier posts on this same subject:

http://www.coade.com/ubbthreads/ubbthrea...=true#Post20421

http://www.coade.com/ubbthreads/ubbthrea...=true#Post20356

Dear Mr. Richard,
Thanks for your tip.
I've added a new material to material database, but CAESAR gives to me this error:

FATAL ERROR #355
Material code arrays have failed in transfer to the error checking module PIERCK. Error reported from PIERCK, routine DUPCOR.

I know that I can also give this data on material "user defined", but my final aim is to create a single file of my personal material to sent to my stress team in other country.Do you think is possible?

Thanks in advance and sorry for my english.

Tips for Adding Materials to the Database:

1) Make sure you add an "All Codes" entry. This will have all of the data except for the allowable stresses. It is this entry that is listed in the Piping Input Droplist for selection. This entry also permits the material to be used with other Piping Codes (aside from your target Code).

2) Make sure that your minimum temperature (in the table) starts below ambient (or you minimum anticipated temperature).