Dear Sir,
Most of the problem In CAESAER 5.10 -Strss Iso Generation
Mainly Open Time PCF File was Error.
I cant Able to Rectify ,Suppose view that message Not possible.
Kindly rectify that or Give the solution.

Use the [Search] button (to the upper right, just above the Calendar) and search for "ISOGEN". There are a number of posts on this issue.

I am also having this issue. Any model gives me the same error: "Error in processing pcf file." The message file seems blank. It reads:

__________________________________________________________________________________
Message enteries for C:\DOCUMENTS AND SETTINGS\GREGORA\DESKTOP\EXAMPLES\RELIEF.pcf file.
__________________________________________________________________________________
Personal ISOGEN : VERSION 5.6.9 (Full)

I applied a register batch file suggested in another discussion, but it didn't help. If anyone has any suggestions it would be greatly appreciated!

You need to install the Visual Fortan run-time library, so you can run through the isometric generation. Please send me an E-mail, and I will reply it with installation package.


Rewgards,

Shawn
szhong@coade.com

Thanks Shawn. I'll await your reply to my email.