Hi boys
I´m a new "old" user of the program.
I just want to rotate axis, with Z vertical, X & Y, 90° less (unclock wise), before starting the input.
It is posible?
thanks and regards

Yes this is possible.

If you want all jobs in "this" data directory to behave this way, then check the "Z Axis Vertical" box on the "Geometry Tab" of the Configuration Module.

If you just want to do this with one job, you can flip the same switch on the "Special Execution Options" dialog of the Piping Input.

Thanks Richard
I do all this steps, but the program allows me to input in two ways.
The traditional Y vertical , Z down left and X down right.
The other Z vertical, y up right and x down right.
What I want is Z vertical, y up left and up right.
I must use the Z vertical, and change the North 90° in my isometric.
regards
Jorge Romero

On the "Iso" toolbar button, use the "fly-out" (the black down triangle) and select the top-most iso-view.