Can one please help me regarding the following Error. I am using flaoting head of type T, with dished head ( Appendix 1, configuration d. The error is regarding Nut/weld clearance. Can anyone explains this ?
Intermediate Calculations For Tubesheets Extended As Flanges:
ASME Code, Section VIII, Div. 1, 2007
Gasket Contact Width, N = (Goc-Gic) / 2 26.000 mm.
Basic Gasket Width, b0 = N / 2.0 13.000 mm.
Effective Gasket Width, b = SQRT(b0) * 2.5 9.082 mm.
Gasket Reaction Diameter, G = Go-2.0*b 733.835 mm.
Bolting Information for UNC Thread Series (Non Mandatory):
Distance Across Corners for Nuts 45.618 mm.
Circular Wrench End Diameter a 65.088 mm.
** WARNING ** Clearance Problems Detected (Nut/Weld)-----------------------------------------------------------------------------
Minimum Actual Maximum
-----------------------------------------------------------------------------
Bolt Area, cm² 108.218 113.755
Radial distance bet. bolts and the edge 26.987 30.000
Circumferential spacing between bolts 57.150 74.493 93.153
-----------------------------------------------------------------------------
_________________________
*************
Farid Masood
Static Equipment Design Engineer
---------------------------------