Dear All
I have problem using the in-line flange report ,there is always message in the report
"Output disabled for field "Torsion Moment"
Output disabled for field "Bending Moment"
Output disabled for field "G/C"
Output disabled for field "AB"
Output disabled for field "Flange Stress"
Output disabled for field "Allowable Pressure /Stress"
Output disabled for field "Ratio"


Report Contains No Data to Display
"
The load case and the criteria are"Flange NC-3658.3 : 7 (OPE) W+T2+P1+WIN1"
I will be appreciated if any one can help
Regarding
Ahmad Akila

Did you specify which temperature you want the flange analysis to use (on the "load case options" tab)?

dear sir
I did modify the load case option and here is the results:
"

Report Contains No Data to Display
" without the disabled output messages.
The load case report info. are :
"CASE 7 (OPE) W+T2+P1+WIN1
Keep/Discard: Keep
Display: Disp/Force/Stress
Elastic Modulus: EC
Friction Mult.: 0.0000
Flg Analysis Temp: T Amb
"
the input of one of the flanges is
" -----------------------------------------------------------------------------
From 1180 To 1185 DY= 98.000 mm.
GENERAL
T1= -80 C T2= -40 C P1= 18.0000 bars PHyd= 27.0000 bars
RIGID Weight= 110.00 N.
WIND
Wind Shape= .800
ALLOWABLE STRESSES
B31.3 (2006) Sc= 138 N./sq.mm. Sh1= 138 N./sq.mm.
Sh2= 138 N./sq.mm. Sh3= 138 N./sq.mm. Sh4= 138 N./sq.mm.
Sh5= 138 N./sq.mm. Sh6= 138 N./sq.mm. Sh7= 138 N./sq.mm.
Sh8= 138 N./sq.mm. Sh9= 138 N./sq.mm. Sy= 198 N./sq.mm.
-----------------------------------------------------------------------------

"

Thank you in advance

Did you check the "Flange" checkbox,and select either the "Peq" or "NC" methods (with associated data)?

If you can't figure it out, send your "c 2" file to techsupport@coade.com.