HI EVERYONE

I NEED TO INPUT THE FOLLOWING VALUES OF WIND PROFILE (PRESSURE VS. ELEVATION)

[m].............[KN/m2]
0 ÷ 10............0,55
10÷ 20............0,62
20÷ 40............0,75

HOW IS THE PRECISELY WAY TO INPUT THE VALUES INTO THE SOFTWARE?
ACCORDING TO THE ABOVE VALUES, I SHOW SOME POSSIBILITIES TO LOAD INTO THE USER WIND PROFILE INPUT.

1.

[m]........[KN/m2]
0...........0,55
10..........0,62
20..........0,75
40..........0,75

2.

[m]........[KN/m2]
0...........0,55
10..........0,55
10,001.....0,62
20..........0,62
20,001.....0,75
40..........0,75

3.

[m]........[KN/m2]
10..........0,55
20..........0,62
40..........0,75


BY THE WAY, HOW DOES THE SOFTWARE INTERPOLATE THE VALUES OF USER WIND PROFILE INPUT, LINEARLY OR IN STEP FUNCTION?.

REGARDS

JCH

CAESAR II uses linear interpolation between the values you specify. So if you define this profile:

 Elevation  Pressure
    0            20
   10            40
   20            60
   30            80


then:

• at an elevation of 5, the pressure used would be 30
• at an elevation of 25, the pressure used would be 70