Hello everyone,

Once again having problems with my vessels. I want to model a saddle, with no wear plate and just one rib. When I set wear plate parameters to 0 and put the number of ribs = 1 I can´t see the rib in the model. When I change number of ribs to 2 then I get the 2 ribs in the model. Is there any problem with using only one rib?

Thanks in advance for the input.

Bellucci

Hi,

PVElite will not carry out a buckling check on a saddle with only one rib. Analyse your model and check the warnings in the output.