Dear Richard,

I am trying to design a flange with metric (mm )units and import the flange dimensions by lookup table option available. However, the imported flange dimensions are always in inches.

When I move the cursor, the units required is given as mm in the cells.

I have tried this with integral flange only and will check the other flanges.

Is this a bug or am I doing something wrong?

Best regards,

Ibrahim Demir

Dear Richar,

I must add that I am trying to design larger size flange that dimensions are given in ASME B16.47 Series B.

If I use lookup table for ASME B16.5 flanges the unit appeares to be "mm" in the flange design option with my selection of units. But this does not work for larger size flanges.

Regards,

Ibrahim Demir

I'll have to test this. However, if you're over the largest size from B16, you need to manually define all of the flange dimensions.

Richard,

I was trying to import size 32 from ASME B16.47 Class B. The manual input is one of the options I could use. I am away from work and shall be back on Manday.

Regards,

Ibrahim Demir