To me when we give a 0 mm gap in Caesar then we give it an extreme condition, but in actual there is 3.00mm gap practically on site. and if there is any requirement then we can give more gap and 've to mention it on Drawings.
Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
You should not attempt to model "construction tolerances", as this can lead to convergence problems. Gaps smaller than 1/8" (3.17mm) likely can't be (reliably) built, so just leave the "gap field" empty.
_________________________
Regards, Richard Ay - Consultant