Exporting TANK Models to CADWorx

Hello all,

I'm fairly new to this software and am currently struggling with the following aspects (I haven't found any threads on either of these subjects, so appologies if this has already been covered):

* Getting the generated 3-D model to export to the CADWorx suite. The options I'm getting to export are HSF and HTML and I'm not sure how I should proceed to achieve this;
* Also, on a related note, is it possible to get the 2D plate flattened layout for an umbrella-type roof from the software? All I can get is the tank's profile, which isn't very helpful for detailed construction drawings.

Thanks in advance for your help.

Kind regards,

Rui Diogo

Hello Rui,

Send this question to my email address ray.delaforce@hexagon.com and I shall get someone to help you.

Thank you Ray, I appreciate it.