Posted by: FAIZOL1982
Weight Summary - 04/26/15 07:39 PM
Dear Team Members,
Found at Intergraph TANK output, the result shown the weight summary but no value are appeared. Any solution for this problem since I'm a new user.
your cooperation and prompt respond are appreciated.
Thanks in advance.
Faizol
Posted by: Richard Ay
Re: Weight Summary - 04/26/15 10:46 PM
All the weights are zero, or just one? I suggest you open a Support Request on Smart Support and send in your input file so that Technical Support can review your exact data.
Posted by: FAIZOL1982
Re: Weight Summary - 04/27/15 12:26 AM
Dear Richard Ay,
All the weights are zero. The output result looked like below:
WEIGHT SUMMARY
--------------
Shell (Corroded) .............................(N
Shell (Non-Corroded) .........................(N
Annular Base Plate ...........................(N
Bottom Plate .................................(N
Nozzles ......................................(N
Roof Plates ..................................(N
Roof Framing/Structure .......................(N
Shell Attachments ............................(N
Insulation ...................................(N
Operating Fluid ..............................(N
Water Weight .................................(N
Operating Weight (Non-Corroded) ..............(N
Test Weight (Non-Corroded) ...................(N
Empty Weight (Non-Corroded) ..................(N
Could I send the file to you for you issue this problem?
Thanks in advance.
Faizol
Dear Richard Ay,
Software now work but need to delete previous output file...every time to run. Weight will be summaries in pound correct even we set out in configuration. Advice if i'm wrong
Thanks in advance.
Faizol
Posted by: Richard Ay
Re: Weight Summary - 04/27/15 05:34 AM
No, to send the file you have to initiate a Support Request on Smart Support.
Unless you've configured the program to "append" the output from multiple runs, you shouldn't have to delete earlier output - it should be overwritten.