Lifting Lug Location & Effect on Flange

Kindly find the attached Equipment Drawing & to suggest the following points clarification :

(1) Lifting shall be by option1 or option
(2) if lifting is by option1 , then what should be taken care in the design of flange
(3) in the design of equipments, for flange is there any need to take care the weight above flange , its moment & wind / sesmic force & moment.And how this can be taken care in PV Elite.
(4)Is it practically possibe option2?

Hello ketan

Your question is very specific - not of general interest to other forum members. I suggest you send me the details in a personal email. You can send the PDF's and your request (repeat the information in your forum details) to: techsupport@coade.com

If i use no code and just think simple its recommended to reckon with Wind and other situation what can occur on plantl ifting.

The strength in the the bolts you can take it like a radial force.

Total weight/ square millimeters bolt availble. = N/mm2
You can use this force for Wm1/Wm2 in Coade calculations to estimate the orginated force.

For the lifting lugs, you can use pvelite (wrc107/297) or you can use Nozzlepro/FeMap for a finet element method.

(sorry for my bad english)

Hell Ketan

I have not received the drawing or sketch.