Conical Heads

Posted by: Rodmanc

Conical Heads - 02/02/10 08:11 AM

Hello,

My question is on the following:

I would like to model two conical heads(with straight flange on large end only).
The model build would be as follows:

cylinder
cone
straight side (shell)
cone
cylinder

I'm new to PVElite, was upgraded from CodeCalc.
Program will not locate one of the cylinders correctly(graphics).
Any comments?

Thanks

Posted by: Mukesh

Re: Conical Heads - 02/02/10 08:53 PM

Use the 2nd row from top in PV ELite Menu to build your model by selecting proper element per your equipment from bottom to top.

I have prepared similar model for you as described by you but cant attach as I dont find any attachment button here.

Provide you email Id so I can send you.

Mukesh

Posted by: Mak

Re: Conical Heads - 02/02/10 09:27 PM

Dear Rodmanc,

If u have a problem in modeling the vessel then goto the "PVElite quick start " under the "Help" tab. There u can find how to model the vessel in PVElite.

If still u have problem, then provide u r mail-id, i will send the vessel model as described by u in the above post.