Posted by: JFrazier
Kettle Reboiler Help - 01/27/10 11:59 AM
I am trying to model an existing reboiler in our refinery and need some help. I have finished the shell and now when I enter a U-tube bundle, it protrudes to the channel side rather than into the shell. Any ideas on how to flip this to the other side? Thanks,
Posted by: Scott_Mayeux
Re: Kettle Reboiler Help - 01/28/10 07:36 AM
Hi J,
In PV Elite under the Tubesheet Properties tab, there is a checkbox titled:
"Tubesheet Assembly is down/left". Try checking the box. Another alternative is to re-model the unit as if you were standing on the other side (180 deg.) of the the exchanger.
Posted by: JFrazier
Re: Kettle Reboiler Help - 01/28/10 09:16 AM
Scott,
The check box did it. Thanks,