Posted by: yl0525
Min. Gasket Contact Width (Nmin) - 11/04/08 10:13 PM
Hi,
I am new to PVElite and I have a doubt on the flange calc on its gasket seating.
I have found "Min. Gasket Contact Width (Brownell Young) [Not an ASME Calc] [Nmin]" just below the bolting information. I wonder what is it trying to mean that it is 'not an ASME calc'? Is this a mandatory requirement whereby the calculated min width shall be used for gasket selection in actual fabrication?
Thank you,
yl0525
I am new to PVElite and I have a doubt on the flange calc on its gasket seating.
I have found "Min. Gasket Contact Width (Brownell Young) [Not an ASME Calc] [Nmin]" just below the bolting information. I wonder what is it trying to mean that it is 'not an ASME calc'? Is this a mandatory requirement whereby the calculated min width shall be used for gasket selection in actual fabrication?
Thank you,
yl0525