how to make vessel.

our plant has one reactor and i want to check the design. it contains
spherical dome
upper cylinder
upper cone
main cylinder
13 degree upper cone
13degree lower cone
spherical section
13 degree lowest cone
lowe cylinder
discharge cone

i can make whole vessel except spherical section which cam between it.

how to make it plz help.......refer the attached figure.

mail me on keyurp84@gmail.com so i can send u the drawing.

Dear Keyur,

You can attach an image in your post in discussion forum itself, go to the bottom of the message click on the "reply" or "Edit" link. then you will see the link for the "File Manager".

thanx mandeep for your help okey check the attached file and tell me how to make the spherical section its on node 40 to 50.

i have make it but as you can see in model the upper cone is come inside this spherical section.

please help me out...

Dear Keyur,

I could not open your file. Please send a drawing (or sketch) and your PV Elite input file to support@coade.com and put it to my attention.