convertface send just 6 faces to 3d shapes!!!

Hi, there's a prob with convertface command, when a exect this, the solid(piping, valves etc)just becomes into just 6 faces and dont like it very much, when the normal is 12, is there a way to set the number of faces to this command?
Thanks a lot

Examine the surftab1 and surftab2 settings in the drawing you are working on. These are initially set at 6.

Good luck,

Tim Storey

Hey, man you were right i feel ridicoulus, it was a AC variable, to set the surfaces tabulation.
Thank you very much.