Posted by: treysoucie
SW Tee ends not iso'ing properly 2019 & 2020 - 02/10/21 08:04 AM
see pics. anyone else having this issue?
Posted by: Vanman
Re: SW Tee ends not iso'ing properly 2019 & 2020 - 02/10/21 10:44 PM
Been some time since I have seen this. From what I can remember this is normally caused by having BW end types assigned to pipe components. This then overrides the SW endtype.
Maybe look at your model and check the ICEDIT properties for the Pipe and the Tee.
Posted by: treysoucie
Re: SW Tee ends not iso'ing properly 2019 & 2020 - 02/11/21 07:23 AM
ya that was it, we had pipe in the spec set to BW end types, we blanked the end types out to show "default" and this cleared it up. thanks