Pipe Support Question - 2 Piece Stop

I have a pipe support that has two pieces of angle that are not connected, but their position of separation is relative to steel member (see attachment 1).

I have been able to position one of the angle elements to the correct "Z" position (see attachment 2).

But I am not sure how to make this work in the "X" direction (parallel to the centerline of the pipe). Can anyone give a suggestion that might work? I assume for the second angle iron you replicate the first one but do it in the other direction.

SaturnV

Are you wanting to place the I section and angles in one operation ?

That would be preferable. But I would settle for a two-step operation just to get it done.

SaturnV

I may have something going.

SaturnV