Posted by: jdright2711
Pipe and Bolt Length - 08/30/19 04:07 AM
IS there a way to reduce the number of characters after the decimal point when setting a pipe length or bolt length in spec gen and in the isometrics BOM?
Posted by: MattCB
Re: Pipe and Bolt Length - 08/30/19 06:39 AM
I think it is DIMDEC, which controls the precision of the DIMUNITS.
Posted by: jdright2711
Re: Pipe and Bolt Length - 08/30/19 08:08 AM
Great thanks for that, exactly what i was looking for.
Posted by: jwood
Re: Pipe and Bolt Length - 09/03/19 02:31 PM
I believe this applies to structural plate.