Posted by: shollinger
Mitered Ell - 06/28/19 05:17 AM
I can not get the mitered ells to come in correctly.
I have added the data table, and updated the piping spec.
the fitting comes in with all the right data. it is just not displaying correctly
Posted by: dgorsman
Re: Mitered Ell - 06/28/19 04:58 PM
What happens if you lengthen the legs? It looks like pipes are interfering with each other as-is. Even a conventional ell would fail like that.
Posted by: shollinger
Re: Mitered Ell - 07/02/19 04:42 AM
I get the same results.
just longer legs.
not even the 5 segments
Posted by: Vanman
Re: Mitered Ell - 07/02/19 06:04 AM
Tha looks like a units mismatch to me. Check the catalog properties to make sure it is English/Inch and not Metric/Inch.
Posted by: Vanman
Re: Mitered Ell - 07/02/19 11:31 PM
Verify the catalog units from here :
Edit to add, I created a mitered elbow using your dimensions for 60" worked fine on my imperial catalog/prj