Posted by: FRS
Slope Line 7mm - 01/02/13 05:14 PM
I am using CadWorx 2013 R1 and I am trying to place a slope line with slope of 7mm in 1m. and I am unable to place the same due to following error message, "Angle of bent that will be created is too small..."
Try placing a tee and then connect pipe with S slope, m meter, m meter, 7
Please advise,
Thanks,
FRS
Posted by: Vanman
Re: Slope Line 7mm - 01/07/13 03:53 AM
It could be that your trimmed elbow rule is turned off and hence not allowing you a shallow angle.
Posted by: shollinger
Re: Slope Line 7mm - 01/10/13 06:50 AM
are you using the pipe router or changing the ucs?
Posted by: raff70
Re: Slope Line 7mm - 03/20/14 02:09 AM
I'm getting the same problem. My trimmed elbow is turned to automatic and I'm using the the pipe router. Any suggestions?
Posted by: NickSyms
Re: Slope Line 7mm - 05/08/14 06:45 AM
Not sure if this topic is dead or resolved, but what angle are you trying to trim your elbow too? also what spec are you using?
Posted by: Tim Storey
Re: Slope Line 7mm - 05/08/14 09:52 AM
Possibly a bend or a miter would work better. An angle of less than 8 degrees makes end preparation of the trimmed elbow a challenge.
Posted by: PaoloDP
Re: Slope Line 7mm - 03/30/18 03:23 AM
The way to go workaround with this issue is to make line from start point CL of 1000mm length and then go up or down 7mm with line (+ or -). Now you have 7mm per meter, create pipe from start point and use SKEW (K-shortcut) and snap it on that second point. And then you have your slope. Works perfectly. Isometric too.