Posted by: CUSTOMUPSTREAM
Cadworx 2012 Threaded items - 08/13/12 11:03 AM
Hi,
I am trying to drawing threaded flanges but i am getting a warning dialogue box "current specification and configuration does not allow this size, cancel only".
My main size is set at 2 and my red size is set at 1. I have also tried main size set at 1.
It was working in cadworx 2010 but not in cadworx 2012.
Thanks,
Customupstream
Posted by: Rocker
Re: Cadworx 2012 Threaded items - 08/13/12 01:08 PM
Do you have any pipe defined at 1"?
Posted by: CUSTOMUPSTREAM
Re: Cadworx 2012 Threaded items - 08/13/12 04:03 PM
Yes i do.. i have attached a chart showing my optional items for pipe.
Thanks,
Custom Upstream
Posted by: Tim Storey
Re: Cadworx 2012 Threaded items - 08/16/12 07:19 AM
Does drawing threaded flanges work when you use the Inch-CS-2013.prj?
Posted by: CUSTOMUPSTREAM
Re: Cadworx 2012 Threaded items - 08/16/12 10:15 AM
Hi TBS,
I'm not sure what you mean by "Inch-CS-2013.prj"
Thanks
Posted by: CADMunkey
Re: Cadworx 2012 Threaded items - 08/16/12 03:43 PM
In the setup dialog is the radio button for threaded selected (as opposed to socket weld)?
Posted by: CUSTOMUPSTREAM
Re: Cadworx 2012 Threaded items - 08/16/12 04:09 PM
Hi Cadmunkey,
its set up to threaded in the setup dialog box.
Thanks
Custom Upstream
Posted by: Tim Storey
Re: Cadworx 2012 Threaded items - 08/18/12 09:07 AM
I did not notice you were having this problem in 2012, not 2013.
I guess my question should have been:
Have you tried running this with a out of the box CADWorx specification and do you get the same results?
Posted by: CUSTOMUPSTREAM
Re: Cadworx 2012 Threaded items - 08/19/12 02:04 AM
Hi TBS,
It works using the default cadworx spec. I just can't figure out why my custom specs doesn't work.
Thanks,
Custom Upstream
Posted by: Rod Abbott
Re: Cadworx 2012 Threaded items - 08/21/12 08:14 AM
Can I see your data file for the flange?