Posted by: Chill-N
ATTN: BricsCAD v19 Users and Adaptive Grid Snap - 08/23/19 12:01 PM
In BricsCAD version 19, I found that the new Adaptive Grid Snap feature affects SNAP intervals. When active, this new feature allows the snap distance to vary based on the level of magnification / zoom. This is not desired in CADWorx P&ID if you use SNAP like I do.
To restore the traditional, constant SNAP distance, change SNAPTYPE variable from the default setting of "2" to either:
"0" (zero) for GRID SNAP
or
"1" for POLAR SNAP.
To restore the traditional, constant SNAP distance, change SNAPTYPE variable from the default setting of "2" to either:
"0" (zero) for GRID SNAP
or
"1" for POLAR SNAP.