Posted by: Mike_Krawczyk
Changing Global Coordinates of a Node - 06/28/11 06:34 AM
I have two "sub models" within one model and mistakenly located them about 800 ft apart, which makes viewing the model a chore. I would like to bring the models closer together by changing the global coordinates of the start node of one of the sub-models.
Is there any way to change the global coordinates of an already established node?
Thanks!
- Mike Krawczyk
Posted by: Richard Ay
Re: Changing Global Coordinates of a Node - 06/28/11 01:18 PM
Yes, just click the "globe" button on the tool bar.
Posted by: Mike_Krawczyk
Re: Changing Global Coordinates of a Node - 06/28/11 02:25 PM
Richard - When I click the globe button, it wants to change the coordinates of "Node 10". However, I want to leave that node where it is. Is there a method to change nodes further on in the input?
Thanks!
- Mike Krawczyk
McCormick Stevenson Corp.
Clearwater, Florida, USA
Posted by: Richard Ay
Re: Changing Global Coordinates of a Node - 06/29/11 05:54 AM
Just click [ok] on node 10, the starting node of the next disconnected segment will be displayed.
Posted by: Mike_Krawczyk
Re: Changing Global Coordinates of a Node - 06/29/11 06:21 AM
That did it! I did not realize that the dialog would cycle through the nodes...
Thanks very much, Richard!
- Mike Krawczyk
McCormick Stevenson Corp.
Clearwater, Florida, USA