CAESAR II Report option

I’m experimenting on the Pipe Stress Interface (PSI) in PDMS application, because I want to convert the PDMS design data to CAESAR II for my analysis then returning it back to PDMS. Unfortunately, I wasn’t able to proceed on the conversion of CAESAR II input file to CAESAR II neutral file, because I can’t figure out one of the notes on the procedure of creating a CAESAR II Report file as stated below;

“It is important to select the 132 column report option under Miscellaneous Option rather than the standard 80 column report, otherwise PSI might encounter problems reading back the data.”

To all the experts and Caesar users please help on my problem, kindly explain the note, I’m waiting for your reply, thanks in advance.

-Clyde

132 column report option was in pre 5.0 version.

Documentation need to be updated.

Regards,

Thanks danb, that's why i wasn't able to make it if that's the case, we're using version 5.20 right now. Could you explain what are the documents to be updated and how to update in 5.20 if you don't mind, again thanks a lot, arigato.

You should have one folder "C2_Docu_UP" (and also C2_Docu)and inside you should have C2TR.pdf

Inside this file you have all you need.

Regards,

The "132 Column Report" was renamed to "Extended Report".