Is it not right to use spring near equipment - small Y disp

Posted by: sam

Is it not right to use spring near equipment - small Y disp - 01/17/10 11:24 PM

Dears,

Is it not right to use spring near equipment nozzle - even with small Y disp - just to reduce the load on the connected load-sensitive equipment nozzle ?

I consider it right & safe.

regards,
sam

Posted by: shr

Re: Is it not right to use spring near equipment - small Y disp - 01/18/10 03:28 AM

Hi Sam
I don't believe that there is anything wrong to use spring close to equipment nozzle to reduce nozzle load.
However WNC case need to check to avoid overload on nozzle for installation/shut down situation.

Regards

Habib

Posted by: Bob Zimmerman

Re: Is it not right to use spring near equipment - small Y disp - 01/18/10 10:26 AM

Read previous discussions. In this business you need a good memory and even better "keyword" searches.

http://www.coade.com/ubbthreads/ubbthrea...=true#Post11941

Also heed CraigB's advice below:

http://www.coade.com/ubbthreads/ubbthrea...=true#Post15469