Caesar II and Cadworx model bends

This is my first time using Caesar II. I have imported a model from Cadworx, but when I run the error check I get many errors. Most of these are error 9E and error 10E "Bend element __ to __ is not LONG ENOUGH to contain the bend curvature" and "Element __ to __ following the BEND ELEMENT __ to __ is not LONG ENOUGH to contain the downstream length of the bend curvature" This model is straight from Cadworx, what is causing these errors and how do I fix them?

Thank you

In CADWorx, did you run the "continuity check" before sending the model to c2? If you did not, you should do this first. Actually you should always do this check before exporting the model anywhere.

If you continue to have problems, send the CADWorx model to techsupport@coade.com so we can take a look at it.