Posted by: machoguy
Error on Conversion of Neutral file to caesar file, - 01/07/09 09:26 PM
Good day to all,
I have problem on conversion of neutral file to Caesar file but there is something missing. I need explanation.
Thank you and Regards,
Machoguy
Posted by: Richard Ay
Re: Error on Conversion of Neutral file to caesar file, - 01/07/09 09:30 PM
From looking at your screen shot (your running Version 5.00) and the error message, I'd say you have obtained a neutral file generated by Version 5.10 and you're trying to create a 5.00 model ? For this to work, you'll have to edit the neutral file and manually remove any data that was added for the 5.10 release. If the model is relatively small this isn't a big deal. For large models this is quite a task to do properly.
Posted by: priyan
Re: Error on Conversion of Neutral file to caesar file, - 01/08/09 07:56 PM
Hai Richard,
you mean Elastic Modulus (H1,H2,H3)in material column. I try to erase the Hot modulus value (H1,H2,H3), but i can not do it.Please Give me a guidance.
Posted by: Richard Ay
Re: Error on Conversion of Neutral file to caesar file, - 01/08/09 10:45 PM
It doesn't matter whether the data is defined on the spreadsheet or not. When you generate the netural file Version 5.10 writes two lines for this data. If you haven't defined anything, then zeroes are written. The point is that there are two extra lines of data (for each element) in a 5.10 neutral file compared to a 5.00 neutral file.
Posted by: Jerril
Re: Error on Conversion of Neutral file to caesar file, - 07/18/12 11:00 PM
Good day to all
I am having this trouble of converting a neutral file to caesar ii input file. A run-time error occurs which says
"forrtl:severe (29): file not found, unit 54" . If you have encounetered and solved this kind of error before, please show me what to do. Your help is very much appreciated.
thank you.
Posted by: danb
Re: Error on Conversion of Neutral file to caesar file, - 07/19/12 12:48 AM