Posted by: fred
dynamics analysis Time domain CaesarII 4.1 - 08/09/00 01:25 AM
I DONT UNDERSTAND WHY THE ALLOWABLE STRESSE LIMITS IS HIGHER ON DYNAMICS ANALYSIS THAN ON STATIC ANALYSIS
COULD YOU EXPLAIN ME THAT ?
Posted by: Richard Ay
Re: dynamics analysis Time domain CaesarII 4.1 - 08/09/00 06:53 AM
Dynamic load cases are by default considered as "occasional cases". As such, the allowable is kSh, where "k" is an allowable increase factor defined by the Code.
The actual value of this allowable increase factor is dependent on the frequency of occurance of the load, and can be adjusted in the CAESAR II configuration module.
------------------
Regards,
Richard Ay (COADE, Inc.)