Posted by: corne
Adding negative pressure - 11/27/07 02:19 AM
Hi all,
I recently installed Ceasar II V5.1 and tried to open an older calculation where we have a pipeline that can operate under full vacuum. A pressure of -1 Bar was entered. When I do an error-check I get a message that pressures below 0 are not allowed. The help function however says it is.
Why can't I enter a -1 bar pressure anymore?
I recently installed Ceasar II V5.1 and tried to open an older calculation where we have a pipeline that can operate under full vacuum. A pressure of -1 Bar was entered. When I do an error-check I get a message that pressures below 0 are not allowed. The help function however says it is.
Why can't I enter a -1 bar pressure anymore?