Posted by: I Demir
CAESAR II-Version 5.00.7 -Built 070122- Flange Design-Units - 08/13/07 10:02 PM
Dear Richard,
I am trying to design a flange with metric (mm )units and import the flange dimensions by lookup table option available. However, the imported flange dimensions are always in inches.
When I move the cursor, the units required is given as mm in the cells.
I have tried this with integral flange only and will check the other flanges.
Is this a bug or am I doing something wrong?
Best regards,
Ibrahim Demir
I am trying to design a flange with metric (mm )units and import the flange dimensions by lookup table option available. However, the imported flange dimensions are always in inches.
When I move the cursor, the units required is given as mm in the cells.
I have tried this with integral flange only and will check the other flanges.
Is this a bug or am I doing something wrong?
Best regards,
Ibrahim Demir